Table of Contents
Advertisement
Configuring the Gateway Initially in Provisioning Mode
Step 4
Click Save.
Configuring LAN Parameters using CLI
To configure LAN parameters, use the following CLI command:
Example:
ip addr 192.168.10.2 netmask 255.255.255.0 gateway 192.168.10.1 dns1
192.168.10.200 dns2 192.168.10.201
Resetting the Gateway to Factory Default using GUI
To reset the gateway to its factory defaults, follow these steps:
Step 1
In the MANAGEMENT SETTINGS, click reset factory defaults.
The gateway reset window appears.
Step 2
Click YES to reset the gateway with the factory reset or click NO.
If you have previously saved the gateway configuration file, you can restore the saved configuration settings
Note
to the gateway as described in
Perform a hard reset only if the gateway needs to be reconfigured using its factory configuration as an
Note
unpacked gateway. A hard reset performs the reset of the gateway's IP address, administrator password, and
then it disconnects the gateway from the network. Instead, if you want to reboot the gateway, see
the Gateway using
Resetting the Gateway to Factory Default using CLI
To perform reset the configuration, use the following CLI command:
Device# factory reset config
Factory reset configuration and reboot? Type YES to continue.
Enter
To reset the configuration and data wipe, use the following CLI command:
Device# factory reset default
WARNING: Secure data wipe will be performed on the next reboot. This could take a long time
Saving and Restoring the Gateway
GUI.
in the CLI command to start the device reset.
YES
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
Configuring LAN Parameters using CLI
Settings.
Rebooting
29
Advertisement
Table of Contents
