Table of Contents
Advertisement
Configuring VLAN Settings
Configuring VLAN Settings
Default VLAN configuration factory-set parameters for the gateway are:
Parameter
Management VLAN ID (MVID)
Native VLAN ID (NVID)
To connect the gateway to a VLAN that is part of the local wireless network, follow these steps:
Step 1
In the ADVANCED SETTINGS, click vlan settings.
The VLAN SETTINGS window appears.
Step 2
Check the Enable VLANs checkbox to connect the gateway to a VLAN that is part of the local wireless network.
Step 3
Enter the management identification number of the VLAN in the Management VLAN ID field. For detailed info about
vlan settings and packet management, see
Note
The same Management VLAN ID must be used on all the gateways that are part of the same mesh network.
Step 4
Enter the native identification number of the VLAN in the Native VLAN ID field.
Step 5
Click Save.
Rules for Packet Management
Parameter
Native VLAN processing
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
40
Default value
1
1
Rules for Packet
Management.
Default value
Enabled
Configuring Advanced Settings
Advertisement
Table of Contents
