Configuring Fluidity Settings Using Cli; Configuring Gateway Status - Cisco IEC6400 Installation And Configuration Manual

Table of Contents

Configuring Advanced Settings

The Unit Role drop-down is set to Infrastructure mode, and it cannot be changed.

Note

Step 3

Choose the network type designation for the gateway from the Network Type drop-down list and it must be set in

accordance with the general network architecture. Following are the available options from the network type:

• Flat: Choose this option, if both the mesh network and the infrastructure network belong to a single layer 2 broadcast

domain.

• Multiple Subnets: Choose this option, if the mesh network and the infrastructure network are organized as separate

layer 3 routing domains.

Step 4

Click Save.

Configuring Fluidity Settings using CLI

To enable fluidity, at least one radio interface should be in fluidity mode:

Device# fluidity status enabled

The gateway status window shows information on basic settings (including the gateway's MAC address) and

allows you to download diagnostic data files and view event logs.

In the MANAGEMENT SETTINGS, click status.

• The STATUS window appears.

Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0

Table of Contents