Configuring Advanced Settings
Configuring SNMP Version v2c using GUI
By default, the gateways are shipped from the factory with SNMP in disabled mode.
To change the gateway's SNMP mode to version v2c and configure the gateway, follow these steps:
Step 1
Choose the version v2c from the SNMP mode drop-down list.
The SNMP window appears.
Step 2
Enter the community identity value in the Community ID field.
Important
The same community identity value must be set for all the gateways in the network.
Step 3
Check the Enable SNMP event trap check box to enable SNMP event traps for significant system-related events, and
then enter the network management station (NMS) host name in the NMS hostname field.
Important
The NMS host to which traps are sent must have an SNMP agent that is configured to collect SNMP v2c
traps.
Step 4
Check the Enable SNMP periodic trap check box to enable periodic SNMP traps to send SNMP traps at defined periodic
intervals and then enter the host name of NMS in the NMS hostname field. Enter the notification period (minutes) in
the Notification period.
Step 5
Click Save.
Configuring SNMP Version v3 using GUI
By default, the gateways are shipped from the factory with SNMP in disabled mode.
To change the gateway's SNMP mode to version v3 and then configure the gateway, follow these steps:
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
Configuring SNMP Version v2c using GUI
35