Cisco IEC6400 Installation And Configuration Manual page 42

Table of Contents

Configuring SNMP Version v3 using GUI

Step 1

Choose the version v3 from the SNMP mode drop-down list.

The SNMP window appears.

Step 2

Enter the SNMP v3 username in the SNMP v3 username field.

The same SNMP v3 username must be set for all the gateways in the network.

Note

Step 3

To change the current SNMP v3 password, enter the new password in the SNMP v3 PASSWORD field.

Step 4

Choose the authentication type from the SNMP v3 authentication proto drop-down list. The available options are:

• MD5

• SHA

• SHA-224

• SHA-256

• SHA-384

• SHA-512

Important

The same SNMP authentication protocol must be set for all the gateways in the network.

Step 5

Choose the appropriate encryption protocol from the SNMP v3 encryption drop-down list. The available options are:

• No Encryption

• DES (Data Encryption Standard)

• AES (Advanced Encryption Standard)

Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0

Configuring Advanced Settings

Table of Contents