Table of Contents
Advertisement
Configuring Advanced Settings
The same encryption protocol must be set for all the gateways in the network.
Note
Step 6
To change the encryption passphrase, enter a new passphrase in the SNMP v3 encryption passphrase field.
Step 7
Check the Enable SNMP event trap check box to enable the SNMP event traps for significant system-related events
and then enter the host name of NMS in the NMS hostname field.
The NMS host to which traps are sent must have an SNMP agent configured to collect v3 traps.
Note
Step 8
Check the Enable SNMP periodic trap check box to enable the periodic SNMP traps to send SNMP traps at defined
periodic intervals and then enter the host name of NMS in the NMS hostname field. Enter the notification period (minutes)
in the Notification period.
Step 9
Click Save.
Configuring NTP using GUI
The gateway has NTP functionality that allows it to synchronize the time settings with a chosen network time
server.
Important
To change the NTP settings, follow these steps:
Step 1
In the ADVANCED SETTINGS, click ntp.
The NTP - Network Time Protocol window appears.
Step 2
Check the Enable NTP check box to enable the NTP synchronization.
Step 3
Enter the host name of a chosen primary NTP server in the NTP server hostname field.
Step 4
Choose the authentication method from the NTP authentication drop-down list. Following are the available options:
The same NTP configuration must be set for all the gateways in the network. If the same NTP settings are
not applied to all gateways, the network may encounter timestamp conflicts and/or device malfunctions.
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
Configuring NTP using GUI
37
Advertisement
Table of Contents
