Configuring New Login Credentials Using Cli - Cisco IEC6400 Installation And Configuration Manual

Configuring New Login Credentials using CLI

Configuring New Login Credentials using CLI
You can access the gateway's CLI using either of the following methods:
• Through SSH from data ports, see
• Through CIMC CLI, see
To know the default IP address for SSH connection, see
Mode, on page
Step 1 To configure new login credentials using the GUI or CLI, see
The default login credentials are:
Note
username: Cisco
password: Cisco
Step 2 To reset the login credentials, use the following example credentials:
username: demouser
password: DemoP@ssw0rd
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
18
Log into the Gateway Configurator for the First Time, on page 15
Accessing Gateway's CLI from CIMC CLI, on page 15
22.
Log into Gateway Configurator for the First Time
Configuring the Gateway Initially in Provisioning
Rules to Reset the Login Credentials.