Table of Contents
Advertisement
Rebooting the Gateway using GUI
DO NOT POWER OFF THE DEVICE DURING THIS OPERATION!
Perform DATA WIPE (Configuration, logs, crashfiles) and reboot? Type YES to continue.
These files are cleared as part of this process:
1)Config, Bak config files
2) Crashfiles
3) syslogs
4) Boot variables
5) Pktlogs
6) Manually created files
Do you want to proceed? (y/n)
Enter
process.
Rebooting the Gateway using GUI
Before you begin
This procedure allows you to reboot the gateway's operating system.
Step 1
In the MANAGEMENT SETTINGS, click reboot.
The gateway reboot window appears.
Step 2
Click Yes to reboot.
Rebooting the Gateway using CLI
To perform a reboot, use the following CLI command:
Device#reboot
Proceed with reload command (cold)? [confirm]
Enter
Saving and Restoring the Gateway Settings
The LOAD OR RESTORE SETTINGS window allows you to perform the following tasks:
• Save the gateway's current software configuration as a configuration (*.conf) file.
• Upload and apply a saved configuration file to the current gateway.
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
30
in the CLI command to start the device reset of the configuration and data wipe or enter
y
in the CLI command to start the device reboot.
confirm
Configuring the Gateway Initially in Provisioning Mode
to abort the
n
Advertisement
Table of Contents
