Setting The Needle Bar Height - Dürkopp Adler 806N-111-10 Service Instructions Manual

Machine head 111

4.4.3 Setting the needle bar height

Fig. 16: Setting the needle bar height
(1) - Screws
(2) - Needle
Proper setting
In the loop stroke position, the hook tip (3) should be situated more or less
below the middle of the needle groove (2) when the machine is set to zig-
zag mode.
To set the needle bar height:
1. Press the Lift/lower sewing head
 The sewing head lowers.
2. Press the O button.
 Threading mode is switched on.
3. Loosen the screws (1).
4. Change the height of the needle bar in such a way that the tip of the
5. Tighten the screw (1).
Important
Following a correction, check the position of needle guide and hook guard.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
WARNING
Risk of injury from sharp parts!
Puncture.
The machine must be set to Threading mode.
hook is positioned slightly (approx. 0.3 mm) below the middle of the
needle groove. Do not move the needle bar while making this adjustment.
③
①
②
(3) - Hook tip
button.
37