Machine head 121
5.9.6 Setting the cutting pressure
Fig. 69: Setting the cutting pressure
(1) - Screws
(2) - Knife
(3) - Thread-pulling knife
Proper setting
The thread must be cut at a pressure that is as low as possible. A low cut-
ting pressure will keep wear at a minimum.
Two of the thickest threads used must be reliably cut at the same time.
To set the cutting pressure:
1. Loosen the screws (1).
2. Swing the thread-pulling knife (3) under the stationary knife (2).
The blade (4) of the thread-pulling knife (3) must be situated below
3. Set the stationary knife (2) against the thread-pulling knife (3) by tight-
4. Place the thread to be cut alternately to the left and the right.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
WARNING
Risk of injury from sharp parts!
Cutting.
Only set the cutting pressure with the machine
switched off.
①
②
the blades (5) of the stationary knife (2).
ening the screws (1).
③
④
(4) - Blade
(5) - Blade
⑤
95