Setting The Lateral Position Of The Thread-Pulling Knife - Dürkopp Adler 806N-111-10 Service Instructions Manual

4.11.2 Setting the lateral position of the thread-pulling knife

Fig. 34: Setting the lateral position of the thread-pulling knife
(1) - Bobbin capsule lug
(2) - Thread-pulling knife
Proper setting
The thread-pulling knife 2 should travel at a safe distance along the bobbin
capsule lug 1.
The thread-pulling knife 2 must not collide with the bobbin capsule 3.
To set the lateral position of the thread-pulling knife:
1. Press the Lift/lower sewing head
 The sewing head lowers.
2. Press the O button.
 Threading mode is switched on.
3. Loosen the screws (4).
4. Set the position of the thread-pulling knife (2) accordingly.
5. Tighten the screws (4).
56
WARNING
Risk of injury from moving parts!
Crushing.
The machine must be set to Threading mode.
①
②
③
(3) - Bobbin capsule
(4) - Screws
button.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Machine head 111
④