Table of Contents
Advertisement
Installing and Setting up the Machine > Default Settings of the Machine
Configuring the Connection by Using Push Button
When your computer or mobile device does not support Wi-Fi Direct but supports WPS, you can configure the
network using push button.
1
Display the screen.
[System Menu / Counter] key > [System/Network] > [Network] > [Wi-Fi Direct Settings] > [Wi-Fi Direct]
2
Configure the settings.
[Wi-Fi Direct]: [On] > [Close]
3
Restart the network.
[System Menu / Counter] key > [System/Network] > [Network] > [Restart Network] > [Yes]
4
[Home] key > [Task Screen] > [Wi-Fi Direct]
5
Press the push button on the computer or mobile device and select "Wi-Fi Direct"
[Push Button Setup] > [OK] on the screen of operation panel.
The network between this machine and the computer or mobile device is configured.
IMPORTANT
You can connect up to 10 mobile devices at the same time using Wi-Fi Direct setting. When the devices that
support Wi-Fi Direct are connected, if you want to connect other device, disconnect the already connected
devices from the network. The disconnection methods are as follows:
• Disconnect the network from the computer or mobile devices
• Disconnecting all devices from the network on the operation panel
Select [Home] key > [Task Screen] > [Wi-Fi Direct] > [List of Connected Devices] > [Disconnect].
• Configuring auto disconnecting time from the System menu
➡
[Wi-Fi Direct Settings] (page 235)
• Configuring auto disconnecting time from the Command Center RX
➡
Command Center RX User Guide
66
Advertisement
Table of Contents
Troubleshooting
