Kyocera PA4500ci Operation Manual page 264

System Menu > System/Network
Item
[Encryption]
[Basic]
Host Name
Check the host name of the machine. Host name can be changed from Command Center RX.
➡
Changing Device Information (page 94)
TCP/IP Settings
For the setting values, refer to the following:
➡
[TCP/IP Settings][TCP/IP Settings] (page 242)
➡
[Bonjour] (page 245)
➡
[IPSec] (page 245)
MAC Address Filter
Set whether to use MAC Address Filter.
➡
Network Interface Kit Operation Guide
Value: [Off], [On]
Restart Network
Item
[Restart Network]
Select encryption method. If you selected a setting other than [Disable],
enter the WEP key or preshared key. The setting values vary depending
on the Network Authentication setting. Select [Data Encryption].
• If the network authentication type is [Open] or [Shared]
Value: [Disable], [WEP]
• If the network authentication type is [WPA-PSK] or [WPA2-PSK]
*2
Value: [TKIP] , [AES], [Auto]
*2 Not displayed when [WPA2-PSK] is specified in [Network
Authentication].
NOTE
• If you selected [WEP], enter the WEP key. Up to 26 characters can be
entered.
• If you selected [TKIP], [AES], or [Auto], enter the pre-shared key. 8 to
64 characters can be entered.
Restart the network.
256
Description
*2
, [Preshared Key]
Description