Error Messages - Ricoh PENTAX K-1 II Operating Manual

Error Messages

Error Messages
Memory card full
No image
This image cannot
be displayed
No card in the camera
Memory card error
Card is not formatted
7
Card is locked
Cannot use this card
Wi-Fi connection disabled
This image cannot
be magnified
This image is protected
Not enough battery
power remaining to
activate Pixel Mapping
Not enough battery
power remaining to
clean sensor
Not enough battery
power remaining to
update the firmware
116
Description
The memory card is full and no more
images can be saved. Insert a new
memory card or delete unwanted files.
There are no images that can be played
back on the memory card.
You are trying to play back an image in a
format not supported by this camera. You
may be able to play it back on a computer.
There is no memory card inserted in the
camera.
The memory card has a problem, and
image capture and playback are
impossible. You may be able to play back
or recover the images on a computer.
The memory card you have inserted is
unformatted or has been previously used
on another device and is not compatible
with this camera. Use the card after
formatting it with this camera.
The write-protect switch on the memory
card you have inserted is locked. (p.128)
A memory card not compatible with this
camera is inserted.
The capture mode is changed to C
mode while the wireless LAN function is
enabled.
You are trying to magnify an image that
cannot be magnified.
You are trying to delete an image that is
protected. Remove the protection from
the image. (p.103)
These messages appear when you try to
perform Pixel Mapping or Sensor
Cleaning, or to update the firmware if the
battery level is insufficient. Install a fully
charged battery.
Error Messages
Unable to update firmware. The firmware cannot be updated. The
There is a problem with the update file is damaged. Try downloading
firmware update file the update file again.
The maximum folder number (999) is
Image folder cannot being used, and no more images can be
be created saved. Insert a new memory card or
format the card.
The image could not be saved because of
Unable to store image
a memory card error.
The operation could not be The operation failed. Try the operation
completed correctly again.
You are trying to select more than the
maximum number of images for the
following functions.
No more images
• Select & Delete
can be selected
• Image Copy
• RAW Development
• Protect
There are no images that can be
No image can be processed processed using the Digital Filter or RAW
Development function.
This message appears when you try to
perform Resize, Cropping, Digital Filter,
Movie Edit, RAW Development, or Save
This image cannot
as Manual WB for images captured with
be processed
other cameras, or when you try to perform
Resize or Cropping for minimum file size
images.
You are trying to set a function that is not
This function is not available
available with the currently selected
in the current mode
capture mode.
The camera will turn off because its
The camera will turn off internal temperature is too high. Leave
to prevent damage from the camera turned off until it has had time
overheating to cool down before turning on the
camera again.
Shutter release is disabled.
Pictures cannot be taken when a
Ensure the zooming index on
retractable lens is attached and is not
the lens is set to a position
extended. (p.46)
that permits shutter release
Description