Ricoh PENTAX K-1 II Operating Manual page 52

1
Set the mode dial to the desired exposure mode.
Q or R appears on the
status screen for the value that
can be changed.
3
The value that can be changed is
underlined in the viewfinder.
The values of the current camera
settings are displayed on the LCD
panel.
During Live View, D appears for
the value that can be changed.
2
Turn R.
The aperture value is changed in
J, K, L, M, or N mode.
The sensitivity is changed in H
mode.
3
Turn Q.
The shutter speed is changed in
I, K, or L mode.
50
t Memo
• The settings for the exposure can be specified in increments
4.5 4.5
3 0 3 0
1/ 1/ F F
1 0 0 1 0 0
• In L or N mode, the difference from the correct exposure is
• For each exposure mode, you can set the camera operation
99999 99999
99999 99999
u Caution
• The correct exposure may not be obtained with the selected
• In M mode, the drive mode cannot be set to [Continuous
• In M or N mode, [LV Electronic Shutter] of the A2 menu
Reducing Noise when Shooting with a
30 30 F4.5 F4.5 100 100 9999 9999
1/ 1/ Slow Shutter Speed
When shooting with a slow shutter speed, you can reduce
image noise in [Slow Shutter Speed NR] of [Noise Reduction] in
the A2 menu.
Auto
On
Off
of 1/3 EV steps. In [1 EV Steps] of the E1 menu, you can
change the adjustment steps to 1/2 EV steps.
displayed on the EV bar scale while the exposure is adjusted.
for when Q or R is turned or M is pressed. Set in
[E-Dial Programming] of [Button Customization] in the A5
menu. (p.99)
shutter speed and aperture value when the sensitivity is fixed
at a certain sensitivity.
Shooting], [Bracketing], or [Interval Shooting].
cannot be used.
Applies Noise Reduction according to the shutter
speed, sensitivity, and internal temperature of the
camera.
Applies Noise Reduction when the shutter speed is
slower than 1 second.
Does not apply Noise Reduction at any shutter speed.
A2