Ricoh PENTAX K-1 II Operating Manual page 100

4
Press E.
5
Press F.
The screen of Step 2 reappears.
Repeat Steps 2 to 5.
6
Press F twice.
t Memo
• You can check the functions
assigned to the buttons while the
Guide Display feature is active
(p.28).
• You can assign the same function
to X and Y.
• When [One Push File Format] or
[Electronic Level] is assigned to
6
X or Y, pressing the button makes a beep sound. To
disable the beep sound, change the sound setting for each
function in [Sound Effects] of the D1 menu. (p.32)
98
Setting the One Push File Format
You can temporarily change the file format by pressing the
button during shooting. Select the file format to change to when
X or Y is pressed for each [File Format] setting.
1
2
Program AE Program AE
2 5 0 2 5 0 5.6 5.6
F F
1/ 1/
1 6 0 0 1 6 0 0
3
4
t Memo
• When the button is pressed and held, a beep sounds and the
One Push File Format is enabled.
u Caution
• The One Push File Format function cannot be used when
[Memory Card Options] in the A2 menu is set to [Separate
RAW/JPEG]. (p.48)
Set [One Push File Format] to [Fx1 Button] or
[Fx2 Button] in Step 3 of "Setting the Button
Operation" (p.97).
Select Z or Y for [Cancel after 1 shot].
The recording format returns to the [File Format]
Z setting of [Image Capture Settings] in the A2 menu
after a picture is taken.
The setting is retained until any of the following
operations is performed:
Y • When X or Y is pressed again
• When 3, F, or G is pressed, or when the
mode dial or main switch is turned
Select the file format when
X or Y is pressed.
The left side is the [File Format]
setting and the right side is the
changed file format when X or
Y is pressed.
Press F three times.
The camera returns to standby mode.
Fx1 Button Fx1 Button
One Push File Format One Push File Format
Cancel after 1 shot Cancel after 1 shot
Cancel Cancel OK OK