Adjusting Height Of Linkage Switch - Invacare TDX SP2 Series User Manual

Invacare® TDX® SP2 Series
Adjusting Height And Depth of Linkage
• 3 mm Allen key
1. Loosen screws A (height adjustment) or B (depth
adjustment).
2. Move linkage to desired position.
3. Tighten screws.
Adjusting Linkage Orientation
This section only applies to variants with ball joints.
You can additionally adjust the position of joysticks and
remote via ball joints in the linkage. The ball joints are freely
movable and offer you infinite adjustment possibilities.
44
Fig. 5-21
Risk of damage to ball joints
If you tighten ball joints to an improper torque,
they might either come loose or get damaged.
– Tighten the ball joints to a torque of 35 Nm.
• 19 mm wrench (2x)
1. Loosen ball joint A.
2. Position linkage.
3. Tighten ball joint.

5.9.3 Adjusting Height of Linkage Switch

Risk of damage to clamping lever
If you tighten clamping lever to an improper
torque, it might either come loose or get
damaged.
– Tighten clamping lever only hand-tight.
Fig. 5-22
1578997-J