Adjusting The Seat Angle; Manual - Invacare TDX SP2 Series User Manual

3.
On both sides, remove the screws, washers, and cover
plates (1).
4. Remove the screw (2).
5. Adjust the spindle or actuator for the backrest
adjustment to the desired depth. In doing so, use the
labelling on the spindle or actuator as guidance.
6. Retighten the screw (2).
7.
Adjust the bearing sheets (1) to the desired depth. In
doing so, use the labelling on the seat as guidance (2).
8. Mount the cover plates and retighten the screws.
9. Mount the seat plate and replace the seat cushion.
1578997-J

5.12 Adjusting the seat angle

CAUTION!
Adjusting the seat tilt or the backrest angle
changes the geometry of the mobility device
and directly influences its dynamic stability!
– For details regarding dynamic stability,
negotiating gradients and obstacles and the
correct adjustment of seat tilt or backrest angle,
refer to 6.5 Taking Obstacles, page 95 and 6.6
Driving up and down Gradients, page 96.

5.12.1 Manual

The seat angle is adjusted using two perforated plates which
are located right and left under the seat frames.
• 1/2 inch wrench
The picture shows the position of the screws A for manual
seat angle adjustment.
1. Loosen all screws on both sides.
2. Set the required angle.
3. Retighten the screws.
Fig. 5-34
Setup
55