Invacare® Storm®⁴ Series
Positioning Piko Buttons
Risk of damage to screws
If you tighten screws to an improper torque, they
might either come loose or get damaged.
– Tighten the screws to a torque of 3 Nm ± 10 %.
•
4 mm Allen key
•
7/16" wrench
1. Loosen screw C.
2. Move holder to desired position.
3. If necessary, loosen nut D.
4. Adjust holder orientation.
5. Tighten screw C and nut D.
Adjusting Linkage Orientation
You can additionally adjust the position of joysticks and
remote via ball joints in the linkage. The ball joints are freely
movable and offer you infinite adjustment possibilities.
44
Risk of damage to ball joints
If you tighten ball joints to an improper torque,
they might either come loose or get damaged.
– Tighten the ball joints to a torque of 35 Nm.
•
19 mm wrench (2x)
1. Loosen ball joint A.
2. Position linkage.
3. Tighten ball joint.
5.7.3 Adjusting Height of Linkage Switch
Risk of damage to clamping lever
If you tighten clamping lever to an improper
torque, it might either come loose or get
damaged.
– Tighten clamping lever only hand-tight.
1529686-U