Changing The Basic Setting Of The Control; Making The Water Connection - Henny Penny FlexFusion ELECTRIC GOLD COMBI FGE-615 Installation Instructions Manual

Prerequisite Unit switched on

6.3.2 Changing the basic setting of the control

6.4 Making the water connection

1. Turn the Selection operating knob to the Settings symbol.
The indicator light illuminates.
The left display reads "PASS".
The right display flashes "- - - -".
2. Use the right rotary knob to set the password.
The right display shows the password set.
3. Press the "Start Stop" button.
Use the left rotary knob to select "OPt".
4. Press the "Step" button to leave the setting menu.
Basic settings can be changed.
1. Press the "START STOP" button.
Left display flashes the basic setting parameter (see "Unit and
connection data").
"OPt" appears on the centre display.
The right display shows the first set value.
2. Turn the left knob.
Set number.
3. Press the "START STOP" button.
The basic setting can be adjusted.
4. Turn the right rotary knob.
Set new value.
5. Press the "START STOP" button.
Accept changes.
6. Press the "STEP" button twice to leave the Settings menu without
changes.
7. Press and hold the "STEP" button for 3 seconds.
Changes are saved.
"OPt" flashes on the left display.
The centre display shows "Stor".
The unit restarts.
8. Fill out the start-up operation report.
Drinking water installation tasks
Drinking water installation tasks on drinking water lines and the unit
may only be performed by a specialist company, which is approved
by the drinking water utility company in the particular region. The
applicable regional regulations, standards and guidelines must be
observed, as well as the connection conditions imposed by the
drinking water utility company responsible.
Installation instructions
Connecting the unit
39