Henny Penny FlexFusion ELECTRIC GOLD COMBI FGE-615 Installation Instructions Manual page 25

Aligning tray trolley
Prerequisite The floor under and in front of the unit is flat
1. Level the unit by screwing the equipment legs in or out.
2. With poor floor conditions, place spacers on the casters of the tray
trolley.
3. Open cooking chamber door.
4. Move tray trolley into the unit until it stops and check the
alignment.
5. Close the cooking chamber door.
6. Fill out the Start-up operation report.
Aligning tray trolley with insertion system
The Combisteamer can be equipped with the EasyIn insertion system
(optional).
e
d
c
Image: Aligning tray trolley with insertion system
a Tray trolley
b Distance
c Guide rail
1. Level the unit by screwing the equipment legs in or out.
2. Open cooking chamber door.
3. Place the tray trolley against the guide rails.
4. Screw the unit legs in or out until the rollers are 1 mm (0,04 in) —
5 mm (0,2 in) over the guide rails.
5. Retract the tray trolley.
6. Level the guide rails.
The sheet metal sealing strip on the tray trolley should make
full contact (no gaps) with the door seal.
The shelves in the unit are horizontal.
Installation instructions
Installing the unit
b
a
d Unit leg
e Support roller
f Handle bar
f
25