Husky Altanium Delta5 User Manual page 225

User Guide
Figure 15-20 Remove the MCU from the Bracket
10. When you install the replacement MCU, make sure that the screws are pre-installed on
11. Securely hold the MCU and slide it down onto the mounting bracket, so the top MCU
12. Rotate the touch monitor to the full back position. Refer to
13. Install the two bottom socket cap screws and tighten them with the 4 mm right angle
14. Rotate the touch monitor to the full forward position.
15. Tighten the two top socket cap screws with the 4 mm right angle Allen key or hex
16. Connect the Touch Screen Signal, Touch Monitor Power, and VGA or LCD1 (HDMI)
17. Connect all other cables to the bottom of the MCU enclosure if your system has other
18. Remove the lock out equipment and tag from the main power switch.
19. Energize the system at the main power switch.
Remove and Replace the MCU
the upper threaded studs and the screws are left off the lower studs on the back of the
touch monitor.
screws go into the bracket slots.
Allen key or hex wrench.
wrench.
connectors at the bottom of the MCU enclosure.
options.
v 1.0 — February 2020 Maintenance
Figure 15-18.
213