Table 12-5
Cycle Mode - Conditions to Stop (UltraSync-E or Altanium Servo Control Installed) (Continued)
UltraSync-E
Heats Running
Engaged
Condition
Condition
Enabled
Enabled
Yes
No
172
v 1.0 — February 2020
Mold Servo
Cycle Mode
Controller
Conditions
Engaged
Selection
Condition
Shown on
Enabled
Screen
Yes
Yes
Conditions to Stop
If pair of digital inputs (start and end):
•
End digital input does not go high before the cycle
time limit has expired
•
Heats are turned off or not At Temperature
•
Mold Servo Controller is disengaged or disabled
System changes to timed data collection
If one digital input to start and timer to end data
acquisition:
•
Start digital input is not high again before the cycle
time limit has expired
•
Heats are turned off or not At Temperature
•
Mold Servo Controller is disengaged or disabled
System changes to timed data collection
If one digital input to start and end data acquisition:
•
Start digital input does not go high again before
the cycle time limit has expired
•
Heats are turned off or not At Temperature
•
Mold Servo Controller is disengaged or disabled
System changes to timed data collection
Altanium Delta5
Data Collection Stop Conditions