Husky Altanium Delta5 User Manual page 223

User Guide
Figure 15-17 MCU Cable Connections
4.
5.
6.
IMPORTANT!
Only loosen the top fasteners. The top mounting holes in the bracket holding the touch
monitor are slotted and allow the monitor to be removed without removing the top
fasteners completely.
Remove and Replace the MCU
Disconnect all other cables from the bottom of the MCU enclosure if your system has
other options.
Rotate the touch monitor to the full back position. Refer to
Find the two lower screws that hold the MCU to the mounting bracket and completely
remove them with a 4 mm right angle Allen key or hex wrench. Refer to
v 1.0 — February 2020 Maintenance
Figure 15-18.
Figure 15-18.
211