Husky Altanium Delta5 User Manual page 136

5.
6.
Figure 10-10 Remote Load - Assign Mold Setup Dialog Box
7.
8.
124
NOTE:
The user can select what to do with changes that were made before to the
current mold setup. When a request has been started to load a different mold
setup, the system uses this parameter to save or discard the changes.
Touch one of the 63 rows that do not have a mold setup assigned.
Touch the Assign Mold Setup button to start the assignment process.
The Assign Mold Setup dialog window shows the folder structure for the local hard drive
only. Refer to Figure 10-10. The Network and USB buttons will not operate when they
are touched.
NOTE:
Only one mold setup can be selected at a time.
Touch a mold setup file to highlight it and then touch the Accept button.
The new mold setup that you selected is shown. When the applicable remote load ID is
requested, this is the mold setup that will be loaded.
To clear the association, touch the row and then touch the Clear Mold Setup button.
NOTE:
A mold setup cannot be assigned to more than one remote load ID. If the user
tries to do this, the current assigned remote load ID is removed automatically
and the new remote load ID is added.
v 1.0 — February 2020 Altanium Delta5
Remote Load