Husky Altanium Delta5 User Manual page 126

Figure 10-4
Table 10-4
License Number
Update License
View License
Remote Load
Part Counting
SPI
Display Thermocouple
Reading for Manual Zones
Auto Slave Enable
Auto Slave Power Limit
Grid Size
Group Offset
114
v 1.0 — February 2020
Heats Setup - Control Page 2
System Setup Screen - Heats Setup - Control Page 2
Item
The license key is shown.
Used to upload new license file from Local, USB, and Network
drives.
Shows the license information.
Used to select the mold setups that can be loaded directly from
the injection molding machine.
Used to automatically count parts and to set a sack full limit.
If a device is attached to the SPI connector, this section lets you
enable communication with the device and set the
communication protocol.
A global setting that controls if the controller view screens show
the thermocouple readings for zones in manual mode.
Enables or disables Auto Slave.
This value is the limit used by the Auto Slave function to calculate
if the average power output of a candidate zone is in the
permitted deviation of the slaved zone.
Used to change the mainframe layout on the Card Layout screen.
Used to configure the linked systems. The default group offset
setting is 96 zones.
Description
Heats Setup - Control Page 2
Altanium Delta5