Husky Altanium Delta5 User Manual page 144

Table 10-10
Manual
Time
----
----
----
----
----
----
----
----
----
----
----
To cancel the remote standby duration timer, touch the Start or Stop buttons.
132
v 1.0 — February 2020
Remote Standby Operational Description
Delay Remote
Time Time
0:00:00 0:00:00 Trigger
0:00:00 X:XX:XX Trigger
X:XX:XX X:XX:XX Trigger
X:XX:XX 0:00:00 Trigger
X:XX:XX X:XX:XX Trigger
X:XX:XX 0:00:00 Trigger
0:00:00 0:00:00 ON/OFF
0:00:00 X:XX:XX ON/OFF
X:XX:XX X:XX:XX ON/OFF
X:XX:XX 0:00:00 ON/OFF
---- ---- Direct
Input Cycle
Operation - STANDBY Button Select
Mode Enabled
---- System does not enter Standby,
because no timers are set.
---- System immediately enters and
remains in Standby until the timer
completes.
No System delays for a specified time and
then enters Standby until the timer
completes.
No System delays for specified time and
then enters Standby indefinitely.
Yes System delays for a specified time and
then enters Standby until the timer
completes. If the input signal changes
state while the delay timer is active,
the delay timer is reset to the specified
value.
Yes System delays for specified time and
then enters Standby indefinitely. If the
input signal changes state while the
delay timer is active, the delay timer is
reset to the specified value.
---- System enters Standby until the input
signal is not active.
---- System enters Standby until the input
signal is not active or the timer
completes.
---- System delays for a specified time and
then enters Standby until the signal is
not active or the timer completes.
---- System delays for a specified time and
then enters Standby until the input
signal is not active.
---- System enters Standby until the input
signal is not active. If the input signal is
active when the system is started, it
will immediately go into Standby
mode.
Altanium Delta5
Standby Operation Description