Table of Contents
Advertisement
1H� Installation of faceplate
1H� 面板安装
According to different faceplates, there are different faceplate
installations as below:
根据不同面板，面板有如下安装方式：
Note: Remove the mask cover (if there is any mask).
注：取下方外罩遮板（有方外罩时）。
One� Normal pneumatic faceplate installation
Faceplate No�:
一 � 常规气动面板安装方式
面板编号：
K-20341T-PNE
K-24149T
K-23055T-PNE
K-22525T-PNE
1� Installing the cover
1� 遮板安装
As shown, first pass the full flush dark gray and half flush
blue air hoses through the cover. Then push the cover
forward until its lower surface is attached to the hinge ear of
the mask.
如图首先将大冲深灰色及小冲蓝色气管穿过遮板后，向前推
动遮板，直到遮板的表面下层贴在方外罩的铰耳上。
Note: When installing the water tank faceplate by pressing
from front, with the difference between the ambient
temperature and the water temperature greater
than 10°C, it is recommended to add a cover to
the faceplate window. Purchase the suitable model
1413977-SP separately.
注： 水箱面板前按安装，环境温度与水温相差大于 10°C 时，
面板窗口建议增加遮板，请另购 1413977-SP。
2� Installing the locking plate
2� 定位板安装
A. Faceplate press from front or remote installation of mask.
A. 适配前按及远程方外罩安装。
a. When tightening the four fixation pipes on the locking
plate, adjust to the "OPEN" mark as shown.
a. 如图将定位板装上时，把四个固定管调整在标识
"OPEN" 字样装上。
1476533-K2-A
K-75890T-PNE
K-24151T
K-6283T-PNE
K-75891T-PNE
-18-
Cover
遮板
Cover
遮板
Full Flush Dark Gray Air Hose
Half Flush Blue Air Hose
Hinge Ear
Fixation Pipe
固定管
Fixing Lock
固定扣
Locking Plate
定位板
Advertisement
Table of Contents
