Table of Contents
Advertisement
4. 48mm-58mm of the long screw shall be reserved outside
the wall as shown in the illustration. if the long screw
outside the wall is not long enough or much longer than
that needed, it should be adjusted with screwdriver or by
hand. Then apply lubricant to drainage pipe and limber
pipe to ensure a smooth installation.
4.
5. Install the toilet as shown in the illustration, and use a spirit
level to ensure the lavatory to remain level.
5.
6. Install the reserved lock, gasket, hexagonal nut and
decoration cap onto long screw according to the order
shown in the illustration.
Note:
Please refer to the installation instructions of toilet.
6.
E. Faceplate Installation
E.
According to different faceplates, there are different faceplate
installations as below:
1.
K-20341T-PNE/K-75890T-PNE
1. K-20341T-PNE/K-75890T-PNE
1)
When tighten four locknuts on supporting board, adjust
to "OPEN" mark as shown.
1)
OPEN
1288818-T01-B
48mm-58mm
installation
48mm-58mm
Long Screw
Reversed Lock
Gasket
Hexagonal Nut
Decoration Cap
Supporting Board
Locknut
-13-
Long Screw
Lubricant
Spirit Level
Advertisement
Table of Contents
