Table of Contents
Advertisement
8. Install the toilet as shown in the illustration, and use a spirit
level to ensure the toilet remains level.
8. 如图将座便器装上，并用水平尺测量座便器是否平衡。
9. Install the reserved lock, washer, hexagonal nut and
decoration cap onto the long screw in the order shown in the
illustration.
Note: Please refer to the installation instructions of the toilet.
9. 如图首先将倒扣、垫片套在长螺杆上。然后拧紧六角螺母，
最后盖上装饰盖即可。
注：实际安装座便器时，依照对应座便器的安装方法。
1G� Installation of faceplate
1G. 面板安装
According to different faceplates, there are different faceplate
installations as below:
根据面板不同，面板有如下安装方式：
Note: Remove the mask cover (if there is any mask).
注：取下方外罩遮板（有方外罩时）。
One. Normal pneumatic faceplate installation
Faceplate No.:
一 . 常规气动面板安装方式
面板编号：
K-20341T-PNE
K-24149T
K-23055T-PNE
K-22525T-PNE
1. Installing the cover
1. 遮板安装
As shown, first pass the full flush dark gray and half flush blue
air hoses through the cover. Then push the cover forward
until its lower surface is attached to the hinge ear of the mask.
如图首先将大冲深灰色及小冲蓝色气管穿过遮板后，向前推动
遮板，直到遮板的表面下层贴在方外罩的铰耳上。
Note: When installing the water tank faceplate by pressing
from front, with the difference between the ambient
temperature and the water temperature greater
than 10°C, it is recommended to add a cover to
the faceplate window. Purchase the suitable model
1413977-SP separately.
注： 水箱面板前按安装，环境温度与水温相差大于 10°C 时，
面板窗口建议增加遮板，请另购 1413977-SP。
1456149-K2-A
K-75890T-PNE
K-24151T
K-6283T-PNE
K-75891T-PNE
Long Screw
长螺杆
Reversed Lock
倒扣
Washer
垫片
Hexagonal Nut
六角螺母
Decoration Cap
装饰盖
Full Flush Dark Gray Air Hose
大冲深灰色气管
-19-
Spirit Level
水平尺
Cover
遮板
Cover
遮板
Half Flush Blue Air Hose
小冲蓝色气管
Hinge Ear
铰耳
Advertisement
Table of Contents
