Table of Contents
Advertisement
Two� Installation of p-trap
二 � 横排安装方法
First of all, there are two discharge pipe installation methods
based on actual situations: A, B.
首先根据实际情况有 A、B 两种排污管安装方法。
A Install 110mm discharge connector onto 110mm drain
outlet on the wall.
A 将 110mm 排污转接头固定在墙面 110mm 排污口上。
B Fixate 115mm rubber gasket onto 90mm discharge pipe,
and then insert into 110mm drainage pipe.
90mm 排污管安装 115mm 橡胶圈后，插入到 110mm
B
排污管内。
Note: 90mm and 110mm in the figure refer to the outer
diameter of the pipe.
注： 图中 90mm、 110mm 均是指管道外径尺寸。
1C� Connecting the water pipe
1C� 供水管连接
Remove the plug, connect the water pipe on the top of water
tank for water supply as shown.
Note: 1. Suggestion: fush the water pipe. Ensure water is clean,
no residual sand stone or fouling inside the pipe.
2. Water pipe may be a flexible hose or hard pipe.
3. Suggestion: Close the stop valve of the In-Wall
Tank after checking for leakage, and open it before
faceplate installation.
如图所示取下堵头后将供水管装在水箱顶部连接管上供水。
注： 1. 建议在连接供水前， 冲洗供水管道， 确保管路中的水干净，
管道内无沙石、污垢等。
2. 供水管可以是软管或者硬管。
3. 建议检查管路密封性后，关闭角阀，安装面板前再打开
角阀。
1D� Connecting cable to socket
1D� 插座接线
As shown, connect the pre-arranged power line to the socket
(K-32789T-*WP, Packed in tank), then fixate the socket with
two screws onto the iron rack.
如图所示，将预留的电源线与插座（K-32789T-*WP，水箱包装
内提供）安装好，再将插座用两颗螺丝固定在铁架与插座的安装
位置上。
Note: K-32784TW-HC, K-32789K-HC, K-32615MY-HC do not
provide socket. The fixed socket needs to be prepared
separately at the socket installation position.
注： K-32784TW-HC、K-32789K-HC、K-32615MY-HC 没有插
座，插座安装位置需要单独准备固定插座。
1476533-K2-A
Plug
Stop Valve
Open
Close
-10-
Water Tank Bracket
水箱架
110mm Discharge
Connector
110mm 排污转接头
90mm Discharge Pipe
90mm 排污管
115mm Rubber Gasket
115mm 橡胶圈
Water Pipe
Connecting Pipe
Suggested Socket
Installation Position
插座建议安装位置
102±2
Socket Installation Position
插座安装位置
Socket (K-32789T-*WP, Packed in tank)
插座 （ K-32789T-*WP ， 水箱包装内提供）
Cable
电线
Screw (K-32789T-*WP, Packed in tank)
螺丝 （ K-32789T-*WP ， 水箱包装内提供）
Advertisement
Table of Contents
