Table of Contents
Advertisement
E. Faceplate Installation
E.
According to different faceplates, there are different faceplate
installations as below:
1. K-22525T-PNE/K-6283T-PNE installation
1. K-22525T-PNE/K-6283T-PNE
1) Mount supporting board onto the mask with 2 screws.
1)
2
2) Install the big flush air hose and small flush air hose to
the cover.
Put the lock on the cover directly on the
reversed lock on supporting board, then push the cover
and lock it. The installation shall begin from bottom to
top.
Note:
Cut the excessive parts of the air hose if
necessary.
2)
3) It is ready to use when connected to water supply after
installation.
Note:
Reserve access panel at front of the tank in
remote installation.
3)
1338609-T01-B
Connect to air hose
-12-
Supporting
Board
Full Flush
Button
Supporting Board
Screw
Faceplate
Lock
Faceplate
Half Flush Button
Advertisement
Table of Contents
