Table of Contents
Advertisement
1E� Installations of reserved access panel
1E� 预留检修口安装
Before Installation
安装之前
A. Remove the cover inside the water tank first as shown. Then
remove the support block above the bracket assembly.
A. 如图首先把水箱上的遮板取下，再取出支架组件上方的支撑块。
B. Connect the full-flush dark gray and the half-flush blue air
hose of the flush valve to the joint of remote air hose.
B. 远程安装时，连接排水阀的大冲深灰色和小冲蓝色气管到远
程气管的对接头。
C. Fixate the cover onto the tank.
C. 水箱遮板装回水箱。
According to demand, there are different
installations of reserved access panel as below�
根据使用需求，预留检修口有如下安装方式：
One� Normal pneumatic faceplate reserved access
panel installation
Faceplate No�:
一 � 常规气动面板预留检修口安装方式
面板编号：
K-20341T-PNE
K-24149T
K-23055T-PNE
K-22525T-PNE
There are three methods to install the reserved access panel:
Method one: Press from front (Mask is reserved access panel)
Method two: Remote pinch installation: fixate four pinches with
screws (Reserve access panel at front of cover)
Method three: Remote installation of mask (Reserve access
panel at front of cover)
首先根据使用需求，预留检修口有三种安装方式：
安装方式一： 前按（方外罩为预留检修口）
安装方式二： 远程扣板安装：四个扣板通过螺丝固定（需在水
箱遮板位置处预留相应大小的检修口）
安装方式三： 远程方外罩安装（需在水箱遮板位置处预留相应
大小的检修口）
1476533-K2-A
K-75890T-PNE
K-24151T
K-6283T-PNE
K-75891T-PNE
Full Flush Dark Gray Air
Hose Of Flush Valve
排水阀大冲深灰色气管
Full Flush Dark Gray Air
Hose Of Flush Valve
排水阀大冲深灰色气管
Method one:
Press from front
Remote pinch installation
安装方式一：
前按
远程扣板安装
Suggested faceplate
installation area
建议面板安装区域
8~69
R1000mm
-11-
Support Block
支撑块
Half Flush Blue Air
Hose Of Flush Valve
排水阀小冲蓝色气管
Half Flush Blue Air
Joint
Hose Of Flush Valve
对接头
排水阀小冲蓝色气管
Remote Full Flush
Joint
对接头
Dark Gray Air Hose
远程大冲深灰色气管
Remote Full Flush
Dark Gray Air Hose
Remote Half Flush
远程大冲深灰色气管
Blue Air Hose
远程小冲蓝色气管
Remote Half Flush
Blue Air Hose
远程小冲蓝色气管
Cover
遮板
Cover
遮板
Method three:
Method two:
Remote installation
of mask
安装方式二：
安装方式三：
远程方外罩安装
Suggested faceplate
Pinch
扣板
installation area
建议面板安装区域
R1000mm
Air Hose
导气软管
Cover
遮板
Air Hose
导气软管
Advertisement
Table of Contents
