After Installation, The Water Supply And Electricity Can Be Connected And Used; Second Method: Installation For In-Wall Tank Without Frame; Installation Of In-Wall Tank; 安装完毕，可以通水或者通电使用 - Kohler K-25839T-NSHC Installation Instructions Manual

4� Fitting the faceplate
4� 面板固定
Put the lock on the faceplate directly on the reversed lock
on locking plate, then push the faceplate and lock it. The
installation shall begin from bottom to top.
将面板的扣位对准定位板的倒扣。然后用力向上推，再向前
扣紧。安装时要注意从下而上安装。
1I� After installation, the water supply and
electricity can be connected and used
1I� 安装完毕，可以通水或者通电使用

Second method: Installation for In-Wall Tank without frame

安装方式二：无框架入墙式隐藏水箱座便器安装
2A� Installation of In-Wall Tank
2A� 隐藏水箱安装
1. Check the height of h1 inlet hole and h2 drainage hole
according to the dimensions of the bowl.
1. 如图首先根据座便器的进水口 h1 和排污口高度 h2 确定水
箱进水口的高度 h1 和排污管的高度 h2。
2. Align the tank on the wall as shown and locate the
installation holes. Mark on the wall for appropriate
position, and drill four holes with diameter of 12mm and
depth of 65mm with churn drilling as shown in illustration,
and fill in the holes with expanding bolt cap.
2. 水箱靠在墙上，在墙壁上把安装孔做记号后，用冲击钻钻
四个 12mm 深 65mm 的小孔，然后安装膨胀螺丝套。
3. As shown, tighten the screw and washer to fixate the
tank.
3. 如图用 4 颗螺丝及垫片将水箱固定。
1476533-K2-A
Faceplate
面板
Lock
扣位
Full Flush
Button
大排按钮
Finished Installation Illustration
h1
Syphon
水箱弯管
h1
Syphon
水箱弯管
-23-
Locking
Plate
定位板
Half Flush Button
小排按钮
安装完毕图
Inlet Hole Drainage Hole
进水口 排污口
h1
Finished
h2
Floor
完工地面
Expanding Bolt Cap
膨胀螺丝套
Faceplate
面板
Washer
垫片
Screw
螺丝