Installation Of Faceplate; 面板安装 - Kohler K-20629T-BW Installation Instructions Manual

7. Remove the protecting hose from the long screw. Adjust
length L of the long screw outside the wall according to the
corresponding toilet. If the long screw outside the wall is
not long enough or much longer than needed, it should be
adjusted with a screwdriver or by hand.
7. 取下长螺杆上的防护套。依照对应的座便器调整长螺杆凸出
来的长度 L。假如长螺杆长度不够或过长就用手或螺丝刀适量
调节。
8. Install the toilet as shown in the illustration, and use a spirit
level to ensure the toilet remains level.
8. 如图将座便器装上，并用水平尺测量座便器是否平衡。
9. Install the reserved lock, washer, hexagonal nut and
decoration cap onto the long screw in the order shown in the
illustration.
Note: Please refer to the installation instructions of the toilet.
9. 如图首先将倒扣、垫片套在长螺杆上。然后拧紧六角螺母，
最后盖上装饰盖即可。
注：实际安装座便器时，依照对应座便器的安装方法。
1G� Installation of faceplate
1G. 面板安装
According to different faceplates, there are different faceplate
installations as below:
根据面板不同，面板有如下安装方式：
Note: Remove the mask cover (if there is any mask).
注：取下方外罩遮板（有方外罩时）。
1402749-K2-A
L
Long Screw
长螺杆
Reversed Lock
倒扣
Washer
垫片
Hexagonal Nut
六角螺母
Decoration Cap
装饰盖
-18-
Long Screw
长螺杆
Lubricant
润滑油
Spirit Level
水平尺
Cover
遮板