Maintenance - Kohler K-25839T-NSHC Installation Instructions Manual

10. Hold the fastener by hand as shown, pull the top of
fastener along the direction of the arrow. Then remove
the fastener.
10. 如图用手握住固定扣的上端向箭头方向拨动，然后取出固
定扣。
11. Pull flush valve along the arrow direction as shown to
remove flush valve.
11. 如图将排水阀按照箭头方向，可使排水阀取出。
B� Maintenance
B� 维护
1. Washing the filtration net
Close the stop valve first, then loosen and take out the
locknut, and rinse the waste from the filtration net with clean
water, then reset the locknut to its original position.
1� 清洗滤网
首先关闭角阀，如图将过滤器的锁紧螺母旋松取出用清水清
洗滤网泥沙，然后将锁紧螺母装回原位锁紧即可。
2� Adjusting the inlet valve
Hoist and reduce the water level in the tank by adjusting
the control pole. Turn the control pole counterclockwise to
lower the floating box and reduce the water level of the tank.
Turn the control pole clockwise to raise the floating box and
increase the water level in the tank.
2� 进水阀的调校
如图调校调节杆可以使水箱水位升高或降低。当逆时针旋转
调节杆时，浮筒下降，水箱水位就低。顺时针旋转调节杆使
浮筒上升，水箱水位高。
1476533-K2-A
Fastener
固定扣
Flush Valve
排水阀
Tighten
拧紧
Inlet Valve
进水阀
-31-
Fastener
固定扣
Stop Valve
Filtration Net
角阀
滤网
Loosen
打开
Locknut
锁紧螺母
Filter
过滤器
Control Pole
调节杆
Floating Box
浮筒
Flush Valve
排水阀