Kohler K-25839T-NSHC Installation Instructions Manual page 27

Two� Intelligent faceplate installation
Faceplate No�:
二 � 智能面板安装方式
面板编号：
K-23056T
K-24147T-7
1� Installing the cover
1� 遮板安装
As shown, first pass the full flush dark gray and half
flush blue air hoses, and the power output cable of the
transformer through the cover. Then push the cover forward
until its lower surface is attached to the hinge ear of the
mask.
如图首先将大冲深灰色、小冲蓝色气管及变压器的电源输出
线穿过遮板后，向前推动遮板，直到遮板的表面下层贴在方
外罩的铰耳上。
Note: When installing the water tank faceplate by pressing
from front, with the difference between the ambient
temperature and the water temperature greater
than 10° C, it is recommended to add a cover to
the faceplate window. Purchase the suitable model
1414279-SP separately.
注： 水箱面板前按安装，环境温度与水温相差大于 10° C 时，
面板窗口建议增加遮板，请另购 1414279-SP。
2� Installing the locking plate
2� 定位板安装
A. When tightening the four fixation pipes on the locking
plate, adjust to the "OPEN" mark as shown.
A. 如图将定位板装上时，把四个固定管调整在标识 "OPEN"
字样装上。
B. Tighten the four fixation pipes to the "LOCK" mark after
installing locking plate as shown.
B. 如图将定位板装上后，把四个固定管旋到 "LOCK" 字样即
可。
1476533-K2-A
K-23056TW
K-78041-7
Locking Plate
定位板
-20-
Cover
遮板
Half Flush Blue Air Hose
小冲蓝色气管
Power Output Cable
变压器的电源输出线
Hinge Ear Full Flush Dark Gray Air Hose
铰耳 大冲深灰色气管
Fixation Pipe
固定管
Fixing Lock
固定扣
Locking Plate
定位板
Fixation Pipe
固定管