Table of Contents
Advertisement
E. Faceplate Installation
E.
According to different faceplates, there are different faceplate
installations as below:
1. K-20341T-PNE/K-75890T-PNE installation
1. K-20341T-PNE/K-75890T-PNE
1)
When tighten four locknuts on supporting board, adjust
to "OPEN" mark as shown.
1)
OPEN
2) Tighten four screws to "LOCK" mark after installing
supporting board as shown.
2)
3) Install the full flush air hose and half flush air hose to the
cover.
Put the lock on the cover directly on the reversed
lock on supporting board, then push the cover and lock
it. The installation shall begin from bottom to top.
Note:
Cut the excessive parts of the air hose if
necessary and fix it onto the tank fastener.
3)
Connect to air hose
1288805-T01-B
LOCK
Supporting Board
-13-
Faceplate
Lock
Supporting
Board
Fastener
Locknut
Fixing Lock
Supporting Board
Locknut
Faceplate
Advertisement
Table of Contents
