Texas Instruments TI-84 Plus Manual Book page 560

• Variables and applications stored in the user data archive of the sending TI-84 Plus
Silver Edition will be sent to the user data archive of the receiving TI-84 Plus Silver
Edition or TI-84 Plus.
After sending or receiving data, you can repeat the same transmission to additional
TI-84 Plus Silver Edition or TI-84 Plus units—from either the sending unit or the receiving
unit—without having to reselect data to send. The current items remain selected.
However, you cannot repeat transmission if you selected
To send data to an additional TI-84 Plus Silver Edition or a TI-84 Plus:
1. Use a USB unit-to-unit cable to link two units together.
2. On the sending unit press y 8 and select a data type and items to
3. Press ~ on the sending unit to display the
4. On the other unit, press y 8 ~ to display the
5. Press Í on the receiving unit.
6. Press Í on the sending unit. A copy of the selected item(s) is sent to the
receiving unit.
7. Disconnect the link cable only from the receiving unit and connect it to another unit.
8. Press y 8 on the sending unit.
9. Select only the data type. For example, if the unit just sent a list, select
The item(s) you want to send are pre-selected from the last transmission. Do
Note:
not select or deselect any items. If you select or deselect an item, all selections or
deselections from the last transmission are cleared.
10. Press ~ on the sending unit to display the
11. On the new receiving unit, press y 8 ~ to display the
Chapter 19: Communication Link
or
All+ All
menu.
TRANSMIT
menu.
RECEIVE
menu.
TRANSMIT
RECEIVE
..
.
SEND
.
4:LIST
menu.
557