Chapter 16: Programming; Volume Of A Cylinder - Texas Instruments TI-84 Plus Manual Book

Chapter 16: Chapter 16: Chapter 16: Chapter 16:
Programming Programming
Programming Programming
Getting Started: Volume of a Cylinder Getting Started: Volume of a Cylinder
Getting Started: Volume of a Cylinder Getting Started: Volume of a Cylinder
Getting Started is a fast-paced introduction. Read the chapter for details.
A program is a set of commands that the TI-84 Plus executes sequentially, as if you had
entered them from the keyboard. Create a program that prompts for the radius R and the
height H of a cylinder and then computes its volume.
1. Press  ~ ~ to display the
2. Press Í to select
prompt is displayed, and alpha-lock is on. Press
[Y] [L] [I] [N] [D] [E] [R]
name the program
You are now in the program editor. The colon (
in the first column of the second line indicates the
beginning of a command line.

Chapter 16: Programming

PRGM NEW
. The
1:Create New
, and then press Í to
.
CYLINDER
menu.
Name=
[C]
)
:
425