Epson Stylus Photo PX700FW Service Manual page 161

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Align the dowels (x2) of the EJ Release Frame Assy L with the
positioning holes (x2) of the Main Frame. (See
Make sure to attach the grounding springs (x2) of the EJ
Frame Assy securely to the EJ Frame Shaft. (See
Fig. 4-114.)
Left side Grounding spring
Figure 4-114. Attaching the grounding spring
Align the dowel (x1) of the EJ Release Frame Assy R with the
positioning hole (x1) of the Main Frame.
When attaching the Spur Gear A, insert the protrusion of the
EJ Frame Assy to the hole of the Paper Guide Front Assy.
Figure 4-115. Installing the EJ Frame Assy
DISASSEMBLY/ASSEMBLY
Fig. 4-113.)
Fig. 4-112,
Right side
Grounding spring
(SeeFig. 4-110.)
Protrusions and holes
EJ Frame Assy
Disassembly Procedures
https://www.manualsbooks.com
After installing the EJ Release Frame Assy L, follow the
procedure below to check the movement of the EJ Release
Trigger.
Rotate the EJ Roller counterclockwise as seen from the left
side, and make the EJ Release Trigger stay on the CR
Guide Plate.
Lift the CR Guide Plate slightly and push the EJ Release
Trigger to the 80 digit side.
Make sure to engage the Spur Gear of the EJ Release
Trigger properly with the Combination Gear of the EJ
Release Frame Assy L, and check if the drive force of the
PF Motor transmits up to the EJ Frame Assy.
EJ Release Trigger
Spur Gear
Combination Gear
EJ Release Frame Left Assy
Figure 4-116. Check for EJ Release Trigger movement
After removing the EJ Frame Assy/EJ Release Frame Assy L/
� � � � �
� � � �
R, make the specified adjustments. (See
�
"ADJUSTMENT".)
� � � � �
After replacing the EJ Frame Assy/EJ Release Frame Assy L/
� � �
R, be sure to perform the required lubrication. (See
"MAINTENANCE".)
Revision C
CR Guide Plate
Chapter 5
Chapter 6
149
Confidential