Epson Stylus Photo PX700FW Service Manual page 153

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Take care not to damage the CDR Tray Sensor when removing the
CDR Tray Assy. (See Fig.
Lift the CDR Tray Assy on the side with arms, remove the CDR Tray Assy to
3.
the rear side of the printer.
Rear side
CDR Tray Assy
CDR Tray
Sensor
Right arm
Groove on CDR Guide
Figure 4-95. Remove the CDR Tray Assy (2)
DISASSEMBLY/ASSEMBLY
4-94, Fig. 4-95.)
Left arm
Dowel on right arm
Disassembly Procedures
https://www.manualsbooks.com
Make sure to insert the dowel of the right arm into the groove
on the CDR Guide. (See
Place the left arm over the right arm before installation. (See
Fig. 4-95.)
If an arm comes off, place it to the CDR Tray at an angle as
shown in Fig. 4-96, and insert the hole of the arm into the hook
on the tray, then rotate it in the direction of the arrow to engage
the arm to the tray.
CDR Tray Assy
Figure 4-96. Reassembling the CDR Tray Assy
When installing the Spur Gear B, engage its teeth with the
grooves on the CDR Tray Assy. (See
After replacing the CDR Tray Assy, make the specified
� � � � �
� � � �
adjustments. (See Chapter 5
�
When replacing the CDR Tray Assy, make sure to carry out
� � � � �
� � �
the specified lubrication. (See
Revision C
Fig. 4-95.)
Hole & hook
Fig. 4-94.)
"ADJUSTMENT".)
Chapter 6 "MAINTENANCE".)
Confidential
141