Epson Stylus Photo PX700FW Service Manual page 138

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
In the next steps, make sure to take measures against
contamination of the surroundings from ink such as receiving it
with BEMCOT or the like.
Using a piece of clean BEMCOT or the like, wipe off the leaked
ink when removing the Printhead.
Make sure not to touch the joint point of the Printhead and the
Ink Supply Tube Assy. (See
Remove the screws (x2) that secure the Ink Supply Tube Assy and remove the
6.
Ink Supply Tube Assy from the Printhead, then remove the Printhead.
Figure 4-60. Removing the Printhead (3)
DISASSEMBLY/ASSEMBLY
Fig. 4-60.)
Printhead
C.B.P. 2x10 (2.5Kgfcm)
Disassembly Procedures
https://www.manualsbooks.com
ASSEMBLING THE PRINTHEAD
When assembling the Printhead, make sure to use the Ink Supply
Tube screwing tool following the procedure in this section in order
to avoid spilling ink from the joint of the Ink Supply Tube Assy and
the Printhead.
Ink Supply Tube screwing tool
Thickness gauge
Figure 4-61. Ink Supply Tube screwing tool
When installing the Printhead, confirm the CR Seal is not
folded or out of position, then install it without any gap in
between.
When the CR Seal gets out of position, make sure to align the
positioning holes (x2) of it with the dowels (x2) on the Carriage
Unit, then install it without any gap.
CR Seal
Figure 4-62. Installing the CR Seal
When installing the Printhead, make sure to move the Carriage
to the 80-digit side and place it on the Carriage stopper jig in
order to prevent the frame from deforming.
Revision C
Carriage Unit
Positioning hole & dowel
126
Confidential