Table of Contents
Advertisement
Power over Ethernet Specifications
The table below lists general specifications for Alcatel-Lucent's Power over Ethernet support. For more
detailed power supply and Power Source Equipment (PSE) specifications, refer to
"OmniSwitch 6450 Chassis and Hardware Components."
IEEE Standards supported*
Default PoE administrative status
Default PoE operational status
Models supporting PoE
Cable distances supported
PoE-capable ports per switch
Default amount of inline power available*
Range of inline power allowed*
PoE Power Available*
* For OS6450-P10S switches, PoE support of up to ~75W per port is provided on ports 1 through 4.
These ports are labeled "HPoE" on the chassis front panel. HPoE at ~75W per port must be enabled via
the
lanpower power
The maximum PoE power budget available for all ports is 280W.
OmniSwitch 6450 Hardware Users Guide
command. PoE support of up to 30W per port is provided on PoE ports 5 through 8.
January 2015
Chapter 2,
IEEE 802.3at
HPoE and IEEE 802.3at on OS6450-P10S only,
on ports 1 through 4; see important note below.
Enabled
Disabled (PoE must be activated on a switch-
by-switch basis via the
lanpower start
command.)
OS6450-P10, OS6450-P10S, OS6450-P24,
OS6450-P48
100 meters (approx.)
8 (OS6450-P10 and OS6450-P10S)
24 (OS6450-P24)
48 (OS6450-P48)
31000 milliwatts
3000 - 31000 milliwatts
3000 - 75000 milliwatts (OS6450-P10S only,
on ports 1 through 4; see important note below.)
OmniSwitch 6450-P10: ~ 90W
OmniSwitch 6450-P10S: ~ 280W
OmniSwitch 6450-P24: ~ 410W
OmniSwitch 6450-P48: ~ 780W
page 5-3
Advertisement
Table of Contents
