Table of Contents
Advertisement
Installing Available Rack Mounting Kits
Installing Available Rack Mounting Kits
Note. Some factory-installed screws may need to be removed prior to mounting, depending on the kit
being used.
Installing the OS6450-RM-19-L Rack Mount Kit
A single chassis can also be mounted into a standard 19-inch rack using L-brackets, as shown in the figure
below.
Attach rack mount brackets to both sides of the front of the chassis.The long and short bracket can be
1
mounted on either side of the chassis.
2
Align the holes in the flanges with the rack holes and insert rack mount screws (not provided) through
the bottom hole of each flange and then the top of each flange. Tighten both screws until they are secure
When rack mounting, a clear-
ance of 0.875 inches is recom-
mended above the chassis.
page 3-6
Attach Rack Mount Brackets
No minimum clearance is required below the chassis
assembly. However, be sure that the bottom of the chassis
is not in direct contact with any equipment below.
Rack-mounting Single Chassis
OmniSwitch 6450 Hardware Users Guide
Mounting OmniSwitch 6450 Switches
January 2015
Advertisement
Table of Contents
