1. Cylinder head breather hose
2. Rear brake hose
3. Breather hose (throttle body to cylinder)
A. 1–3 mm (0.04–0.12 in)
B. Position the end of the hose clamp within the
range shown in the illustration. The range is
measured from the center of the white paint
mark on the cylinder head breather hose.
C. Install the breather hose (throttle body to
cylinder) with its yellow paint mark facing
upward.
D. Point the ends of the hose clamp in the
direction shown in the illustration.
E. Install the hose completely onto the hose
fitting.
F. 1–7 mm (0.04–0.28 in)
G. Install the breather hose (throttle body to
cylinder) with its white paint mark facing
upward. Point the ends of the hose clamp
upward.
H. 1–5 mm (0.04–0.20 in)
2-36
CABLE ROUTING