Bearings And Oil Seals; Circlips; Rubber Parts - Yamaha MBK MW125 2014 Service Manual

EAS30010

BEARINGS AND OIL SEALS

Install bearings "1" and oil seals "2" so that the
manufacturer's marks or numbers are visible.
When installing oil seals, lubricate the oil seal
lips with a light coat of lithium-soap-based
grease. Oil bearings liberally when installing, if
appropriate.
ECA13300
NOTICE
Do not spin the bearing with compressed air
because this will damage the bearing surfac-
es.
EAS30011

CIRCLIPS

Before reassembly, check all circlips carefully
and replace damaged or distorted circlips. Al-
ways replace piston pin clips after one use.
When installing a circlip "1", make sure the
sharp-edged corner "2" is positioned opposite
the thrust "3" that the circlip receives.
IMPORTANT INFORMATION
EAS30012

RUBBER PARTS

Check rubber parts for deterioration during in-
spection. Some of the rubber parts are sensitive
to gasoline, flammable oil, grease, etc. Do not al-
low any items other than the specified one to
contact the parts.
1-8