Siemens FS720 Mounting & Installation page 87

Building Technologies
Fire Safety
X400
X401
1
Figure 44: Mounting of the periphery board (4 loops)
1 Threaded bolts on rear panel
2 13 fixing screws
3 Periphery board (4 loops)
X3 Connector for connection cable to PMI & mainboard (operating unit)
X400 Connector for the periphery bus to the fire brigade periphery module [DE]
X401 Connector for periphery bus
Mounting steps
1. Mount the periphery board (4-loop) (3) with the 13 fixing screws (2) to the
threaded bolts (1) that are embedded in the rear panel.
2. Wire up the periphery board (4-loop) according to the pin assignments below.
3. Re-install any modules that you may have had to remove.
Installing, exchanging and connecting modules
Periphery board (4 loops)
X5
X7
X22
X6
X8
X3 X1
X11
X21
X12
2 3
87 | 248
A6V10210390_m_en_--
2018-08-29
7