Siemens FS720 Mounting & Installation page 105

Building Technologies
Fire Safety
Mounting steps
1. At the bottom of the power supply (4), insert the distance pins into the guide on
the rear panel as shown.
2. Fasten the power supply (2 and 3) to the lug at the top (1) using the Phillips
screw.
3. Connect the power supply according to the pin assignment in the next chapter.
Installation of the temperature sensor
5
4
3
y
2
1
Figure 52: Installation of the temperature sensor
1 Batteries
2 Temperature sensor
3 Luster terminal
4 Connection cable to the power supply
5 Connection terminal X11 to the power supply for the temperature sensor
x Approximate distance to the lower edge of the power supply: 20 mm
y Approximate distance to the side wall of the power supply: 5 mm
Installing, exchanging and connecting modules
Power supply (150 W)
7
105 | 248
A6V10210390_m_en_--
2018-08-29