Table of Contents
Advertisement
Custom Install
The following procedure is an example for installing the software in Windows 8.1 using Custom Install.
7
Finish the installation.
When Your software is ready to use appears, you can use the
software. To print a test page, click the Print a test page checkbox
and select the machine.
Click Finish to exit the wizard.
Note When you have selected Device settings in Windows XP,
the dialog box for device setting will appear after Finish is clicked.
Configure the settings for options installed on the machine.
Device settings can be configured after the installation is
completed.
For more information, refer to the Printing System Driver User Guide
If a system restart message appears, restart the computer by following
the screen prompts. This completes the Printing System Driver
installation procedure.
1
Insert the Product Library disk.
Note Installation on Windows must be done by a user logged
on with administrator privileges.
If the Welcome to the Found New Hardware Wizard dialog
box displays, select Cancel.
If the autorun screen is displayed, click Run setup.exe.
If the user account management window appears, click Yes
(Allow).
2
Click View License Agreement and read the License Agreement.
Click Accept.
3
Select Custom Install tab.
4
Select the device to be installed, and click the arrow button to move
it to the Products to Install list.
IMPORTANT If Wi-Fi or Wi-Fi Direct is enabled, be sure to
specify the IP address for the port name.
Installation may fail if the host name is specified.
Note The machine cannot be detected unless it is on. If the
computer fails to detect the machine, verify that it is
connected to the computer via a network or USB cable and
that it is turned on and click
If the desired device does not appear, select Add custom
device to directly select the device.
2-19
Preparation before Use
(Reload).
.
Advertisement
Table of Contents
